© 2022 The Masonry Society. All Rights Reserved.
Custom website design by RunLocal Marketing, Longmont, CO
Design of Movement and Control Joints for Masonry
This lesson addresses the movement characteristics of masonry wall systems, and compares the differences between architectural veneer and structural reinforced masonry. Focus is on best practice for design and construction of expansion and control joints to accommodate and/or restrict masonry material movement.
This course is free to TMS Members. See more membership benefits and become a member here. If you’re already a Member, log in to access this course from your Course Dashboard.
$75.00
Description
This lesson addresses the movement characteristics of masonry wall systems, and compares the differences between architectural veneer and structural reinforced masonry. Focus is on best practice for design and construction of expansion and control joints to accommodate and/or restrict masonry material movement.
Learning Objectives:
- Learn masonry movement and control joint basics and definitions
- Determine movement characteristics of masonry materials and systems
- Understand movement and control joints purpose and location
- Acquire knowledge to design and detail movement and control joints
Related products
-
Structural Masonry Detailing: Confined Lap Splices
Most designers who engineer reinforced masonry know that code provisions for lap splice lengths have been evolving over the past few code editions. This course provides an overview of a newer confinement-steel option that has the potential to significantly reduce the lap splice lengths, especially for larger diameter bars, through confinement of the structural reinforcement.
$75.00 -
Rational Design of Masonry Veneers and Shelf Angle Supports
Chapter 12 of the TMS 402 2016 includes provisions for the design of anchored and adhered masonry veneer. Although the vast majority of anchored masonry veneer systems are designed using the prescriptive provisions within this standard, veneers in high wind zones, high seismic zones, or constructed with large distances between the backing walls and the veneer cannot be designed using these prescriptive provisions. In addition, the prescriptive provisions do not often provide the most cost-effective solutions for the rehabilitation and retrofit of masonry veneers. The TMS 402 does have provisions for alternative rational design provisions for masonry veneers. These provisions are explained and a method for the rational veneer wall system design are presented. This lesson also describes a method for the design of the vertical Shelf angle support of the walls systems.
This course is free to TMS Members. See more membership benefits and become a member here. If you’re already a Member, log in to access this course from your Course Dashboard.
$75.00 -
Design of Masonry Shear Walls
The design of reinforced masonry shear walls using both the Allowable Stress Design method and the Strength Design method is covered in this lesson.
$75.00 -
Special Inspection of Structural Masonry #5 – Grout
This lesson is designed to provide a thorough understanding of grout for new masonry construction, especially as it pertains to the responsibilities of a Special Inspector. It describes the purpose of grout for masonry construction, both fine and coarse, as well as conventional and self-consolidating mixes, and desirable properties for all of these. It describes the materials that comprise grout and explains how grouts are specified, batched, mixed, and placed. Test methods for grout and preparation of test specimens are explained.
Get all 9 Special Inspection of Structural Masonry lessons at a discounted rate when buying the Special Inspection of Structural Masonry bundle. Members save an additional $175 off Member price and Non-Members save $75 compared to buying them separately.
$75.00