Special Inspection of Structural Masonry #9 – Testing
This lesson will review common masonry tests and sampling methods as well as when such test may be appropriate and required by the Quality Assurance/Quality Control programs. Common errors in testing will be discussed to try to reduce such errors from being replicated in the future. Destructive and non-destructive tests and evaluation methods will briefly be reviewed for situations where construction testing was not performed, was not performed properly, or when results are suspect.
Get all 9 Special Inspection of Structural Masonry lessons at a discounted rate when buying the Special Inspection of Structural Masonry bundle. Members save an additional $175 off Member price and Non-Members save $75 compared to buying them separately.
$75.00
Description
This lesson will review common masonry tests and sampling methods as well as when such test may be appropriate and required by the Quality Assurance/Quality Control programs. Common errors in testing will be discussed to try to reduce such errors from being replicated in the future. Destructive and non-destructive tests and evaluation methods will briefly be reviewed for situations where construction testing was not performed, was not performed properly, or when results are suspect.
Related products
-
Design
Strength Design of Masonry #3 – Strength Design of Walls for Axial Load and Out-of-Plane Loads
$75.00 Add to cartStrength Design of Masonry #3 – Strength Design of Walls for Axial Load and Out-of-Plane Loads
During this session, design of masonry walls loaded with out-of-plane loads and axial loads will be reviewed.
Get all 6 Strength Design of Masonry lessons at a discounted rate when buying the Strength Design of Masonry bundle. Save $30 compared to buying them separately.
SKU: LMS2103 Categories: Design, Member Discount-75, Strength Design, Strength Design Series$75.00 -
Design
Strength Design of Masonry #1 – Introduction to Strength Design of Masonry and Design Methodologies
$75.00 Add to cartStrength Design of Masonry #1 – Introduction to Strength Design of Masonry and Design Methodologies
This introductory session will review basic strength design concepts for masonry, noting key differences with procedures for concrete.
Get all 6 Strength Design of Masonry lessons at a discounted rate when buying the Strength Design of Masonry bundle. Save $30 compared to buying them separately.
SKU: LMS2101 Categories: Design, Member Discount-75, Strength Design, Strength Design Series$75.00 -
Structural Masonry Detailing: Confined Lap Splices
Most designers who engineer reinforced masonry know that code provisions for lap splice lengths have been evolving over the past few code editions. This course provides an overview of a newer confinement-steel option that has the potential to significantly reduce the lap splice lengths, especially for larger diameter bars, through confinement of the structural reinforcement.
SKU: LMS2003 Categories: Codes & Standards, Design, Member Discount-75$75.00 -
Masonry 101 #4 – Reinforcement and Anchors
This lesson covers types of reinforcement used in masonry, including bars, joint reinforcement, anchors and ties. Each type of reinforcement will be explored, and the use in masonry will be identified.
Get all 6 Masonry 101 lessons at a discounted rate when buying the Masonry 101 bundle. Members save an additional $50 off Member price and Non-Members save $75 compared to buying them separately.
SKU: LMS2007 Categories: Anchoring, Masonry 101 Series, Member Discount-75, Reinforcement$75.00